Getting Started; Preparing The Remote Control; Installing The Unit - JVC TH-LB3-B Manual De Instrucciones

Getting started

DO NOT connect the power cord until all other connections have been made.

Preparing the remote control

When you use the remote control for the first time, pull out the
insulation sheet.
If the range or effectiveness of the remote control decreases,
replace the battery.
To replace the battery in the remote
control
Insert the battery into the remote control by matching the
polarities (+ and –) correctly.
Lithium coin battery
(product number: CR2025)
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
NOTES
• Store the battery in a place where children cannot reach. If a child
accidentally swallows the battery, consult a doctor immediately.
•
To prevent the battery from overheating, cracking, or starting a fire:
– Do not recharge, short, disassemble or heat the battery, or
dispose of it in a fire.
–
Do not leave the battery with other metallic materials.
– Wrap the battery with tape and insulate when throwing away
or saving it.
–
Do not poke the battery with tweezers or similar tools.
• Dispose of the battery in the proper manner, according to federal,
state, and local regulations.

Installing the unit

Install the unit on a flat and level surface to ensure the best sound
quality.
•
The sound may be affected depending on the location in which
you install it. To avoid such issues, change the location and
orientation of the unit.
•
For cathode-ray tube television (CRT):
– If you install the unit near the TV, color distortion may occur.
To prevent this, turn off the TV's main power or unplug it
before installing the unit. Wait at least 30 minutes before
turning on the TV's main power again.
– If the TV is still affected, move the unit further away.
CAUTION
Do not drag or push the unit on the floor or table. Otherwise, the foot
spacers at the bottom may peel off or drop from the unit.
Installing on the wall
You can install the unit on the wall.
A : 6 – 7 mm
B : Maximum 10 mm
C : Maximum 6 mm
D : φ 4 mm (screw diameter)
E : Minimum 15 mm
CAUTION
• The unit weighs approximately 3.1 k
taken when installing it on the wall to prevent any accidents
caused by its falling off.
• Use screws, which are compatible with the strength and material of
the pillar or wall to prevent the unit from falling off.
• Do not install the unit onto a plywood or plasterboard wall;
otherwise, it will fall and sustain damage.
•
When installing the unit on the wall;
– Be sure to have it installed on the wall by qualified personnel.
– Care must be taken when selecting a location for installation on
the wall. Injury to personnel or damage to equipment may result
if the installed unit interferes with daily activities.
– AC adaptor should not be hanging/placed above any other items.
Place the AC adaptor on the flat floor only.
3
Screw (not supplied)
g. Sufficient care must be