Operations; Basic Operation - JVC TH-LB3-B Manual De Instrucciones

Operations

Basic operation

Turning on/off the power
Press .
NOTES
• A small amount of power is consumed even when the power is
turned off (standby mode). During standby mode, the STANDBY
indicator lamp on the front panel lights up. Unplug the power cord
from the AC outlet to turn the power off completely.
•
You can also turn on the power by pressing one of the input buttons
(DIGITAL, ANALOG or HDMI) or iPod 6.
Activating/deactivating APS (Auto Power
Save)
The System automatically turns off to save the power.
Press and hold APS.
Each time you press and hold the button, Auto Power Save is turn
on and off (APS ON and APS OFF scroll on the display).
• The System automatically turns off to save the power when one
of the following situations continues for 29 minutes:
•
For all sources:
– When the volume is set to 0.
–
When muting is activated.
For DIGITAL 1/DIGITAL 2:
– When the optical cord or coaxial cord is not connected, or
there is no signal.
For TV ARC (Audio Return Channel):
– When HDMI OUT is not connected, or there is no signal.
For iPod:
– When iPod is not connected to the unit.
For HDMI 1/HDMI 2:
–
When HDMI 1 IN/HDMI 2 IN is not connected, or there is no
signal.
When one of the situations occurs...
The APS indicator is shown for 1 second every 1 minute and starts
flashing 30 seconds before the System turns off.
Selecting the input source
Press one of the input buttons to select the input
source.
DIGITAL:
Each time you press each button, the source changes as follows:
DIGITAL 1 (for the optical connection) \ DIGITAL 2 (for the coaxial
connection) \ TV ARC (for HDMI OUT with ARC)*
ANALOG:
ANALOG IN (for the analog connection)
HDMI:
Each time you press each button, the source changes as follows:
HDMI 1 IN (for HDMI 1)|\ HDMI 2 IN (for HDMI 2)
*
To use TV ARC, set CEC to ON, and make sure your TV supports this
function and has the correct settings.
Adjusting the volume
Press VOLUME +/–.
Adjusts the volume within the range of 0 (MIN) to 40 (MAX).
CAUTION
Set the volume to the minimum level before starting any source. If the
volume is set to a high level, the sudden blast of sound may damage
your hearing and blow out the speakers.
Turning off the sound temporarily
Press MUTING.
•
To restore the sound, press the button again or press VOLUME +
to adjust the volume.
Maintaining steady volume for different
input sources
You can set your desired volume level for different input sources to
avoid volume fluctuation when changing from one source to the
other—TruVolume (TVOL).
Press TVOL.
Each time you press the button, TruVolume is turn on and off (TVOL
ON and TVOL OFF scroll on the display).
Changing the display brightness
Press DIMMER.
Each time you press the button, the display brightness changes
with the following scrolling message:
DIMMER OFF (normal) \ DIMMER 1 (darker) \ DIMMER 2
(darkest)
7