Connecting External Components; Connecting External Component With Hdmi Cable; Connecting The Power Cord - JVC TH-LB3-B Manual De Instrucciones

Connecting external
components
You can connect an analog component to the ANALOG IN terminal
and digital components to the (OPTICAL) DIGITAL IN 1 and
(COAXIAL) DIGITAL IN 2 terminals.
You can also connect a subwoofer to the SUBWOOFER PRE-OUT
terminal.
RCA pin plug cord
(not supplied)
Rear of the unit
R
(COAXIAL)
DIGITAL ANALOG
IN 2 IN
Red
Digital coaxial
cord
(not supplied)
DVD Player, etc.
(not supplied)
Subwoofer
(not supplied)
L
(OPTICAL)
DIGITAL
IN 1
White
RCA pin plug Digital optical
cord cord
(not supplied) (not supplied)
TV, etc. (not supplied)
Connecting external
component with HDMI cable
You can also connect digital components to the HDMI 1 IN and
HDMI 2 IN terminals and HDMI OUT terminal.
This terminal is only for the use in the
factory or the service center.
HDMI cable
(not supplied)
HDMI cable
(not supplied)
DVD player, etc.
(not supplied)
Blu-ray player, etc.
(not supplied)
HDMI cable
(not supplied)

Connecting the power cord

Connect the supplied AC adaptor to the DC IN jack on the unit. Then
connect the supplied AC power cord to the AC adaptor, and plug it
in a wall outlet.
CAUTION
• Disconnect the power cord before cleaning or moving the unit.
•
To avoid the risk of fire and to prevent damage,
– Do not use any AC adaptors other than the one supplied.
– Do not use the supplied AC adaptor for other equipment.
6
TV, etc. (not supplied)
Rear of the unit