Gorgy Timing RADIO TIMING 9S Modo De Empleo/Instrucciones De Montaje página 66

WARNING! Read the section below very carefully before installing your equipment. It gives
the safety instructions that must be followed during installation.
To protect your equipment, connect power on UPS (Uninterruptible Power Supply).
The electrical installation to which the equipment is connected must comply with the NF C
15-100 standard.
This device does not have a primary power switch. A power protection system (circuit-brea-
ker or disconnecting switch), that is easy to access must be built into the wiring installation.
This device must withstand the nominal voltage and current values specified on the clock.
In Europe: To comply with European regulations on the protection of persons and the envi-
ronment, you must dispose of this equipment in a collection site provided for this purpose
(separately from household waste). Contact your reseller, collection site or the competent
local authorities for more information.
If the RT9s does not store the time in its memory after a power failure, the backup battery
may be discharged. To replace it, contact the Gorgy Timing Customer service department
(Contact details on the back of this manual)
Modifying or opening the product without the consent of the Customer service department
will void the warranty.
The RT9s should be installed, maintained and handled only by competent persons.
All maintenance operations should be carried out when the equipment is shut down; this is
also applicable to systems connected to any relay outputs.
In general, the power (220V) and signal (time information) cables should not be too close to
one another, to prevent interference. To avoid risk of electrical interference, move the RT9s
as far as possible radiation sources (speakers, antennas, high frequency equipment, elec-
tromechanical rings ...).
Gorgy Timing declines any liability in the event of accidents or damages caused by an impro-
per use of RT9s.
GORGY tIMInG products comply with the following standards: CE, En 60950, En
55022, En 50024.
66
IMPORtant SafEtY InStRUCtIOnS
MDE-RT9s-3079V1.0