Selection Of Installation Equipment - Candy CIVS 677 Manual De Instrucciones

9. Installation

9.1 Selection of installation equipment

Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole.
Be sure the thickness of the work surface is at least 30mm. Please select heat-resistant work surface
material to avoid larger deformation caused by the heat radiation from the hotplate. As shown below:
L(mm) W(mm)
590 520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet and
outlet are not blocked. Ensure the induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at
least 760 mm.
A(mm) B(mm)
760 50 mini
H(mm) D(mm)
56.5 52.5
C(mm)
20 mini
EN-18
A(mm)
560+4
+1
D E
Air intake Air exit 5mm
B(mm) X(mm)
490+4 50 mini
+1