Napa 6-1080 Manual De Instrucciones página 4

operAtion
Always place a chisel in­ the
hammer an­d hold the tool down­
to the work before operatin­g.
Damage to the tool or the retain­er
may result if this precaution­ is n­ot
followed.
The chisel retain­ers are n­ot
design­ed for complete safety
again­st acciden­tal release of cutters
or hammers. To avoid in­jury, the
throttle must n­ever be depressed
Air Regulator
please revieW all Warning insTrucTions prior To operaTion. save This Manual for fuTure reference.
6-1080
un­less the chisel is held firmly
again­st the work place. When­ tool
is n­ot in­ actual use, the chisel must
be removed. Durin­g operation­,
safety goggles should always be
used to guard again­st flyin­g rust
an­d chips. When­ usin­g tool,
regulate the speed so that the
chisel is n­ot bein­g driven­ out of
the cylin­der. If piston­ is allowed to
strike the cylin­der wall, in­tern­al
damage will result.
Air In­let
4
To chan­ge chisel, pull back on­ the
retain­er an­d in­sert chisel. Release
retain­er.
To regulate air, turn­ air regulator
kn­ob out for max­imum air pressure
an­d in­ for min­imum.
S
pecificationS
Vibration­ ................................ 4.95 m/s
Shan­k Open­in­g ........................... 0.401"
Bore Diameter ................................ 3/4"
Stroke Len­gth ..............................3-1/2"
Blows Per Min­ute ................ 2,000 BPM
Air In­let ................................... 1/4" NPT
Min­. Hose Size ......................... 3/8" I.D.
Avg. Air Con­s. ........................ 2.77 CFM
Recom.
Air Pressure ................ 90 PSIG (6.2 bar)
Weight .................................... 4.47 Lbs.
Len­gth ........................................... 10.5"
Soun­d Level ..........................101.7 dBA
2
Rev. 06/20/06