FAR RAC 185 Instrucciones De Uso página 11

RAC 185 RAC 185
MAINTENANCE AND CHANGE OF SIZE (fig. f3-f4-f5)
As a result of extended use of the riveting tool, the clamps may
slip on the nail due to deposited impurities.
It will therefore be necessary to clean and then lubricate the
clamps; if they are worn to such a degree as to impair operating
efficiency they must be replaced.
Remove the head carrying the nozzle (B) with the aid of a standard
27 mm spanner. After removing the head, use a standard 16 mm
spanner to remove the chuck (P) and extract the clamps (M).
When replacing the nozzle (A), use a standard 12 mm spanner
and place the removed nozzle in the housing provided on the
bottom of the riveting tool so as to avoid losing it.
WARNING!
Desconnect air feed when performing those
operations.
f3
B
B
Revision - 00
GB
f4
27 mm
Date 11-2011
16 mm
f5
A
A
B
12 mm
11