BH FITNESS G6522 Instrucciones De Montaje página 13

13 Use the handrail to help you get on
and off the
changing the speed. Do not jump onto
the belt while it is moving.
14 Keep your hands well away from
any of the moving parts. Do not place
your hands, feet or any other object
below the treadmill belt.
15 Use suitable clothing and footwear.
Make sure that all laces/cords are tied
correctly. To
unnecessary wear on the belt, make
sure that your footwear is not dirty.
16 It is not advisable to keep your unit
in a damp place for long periods as it
will be prone to rust.
17 Make sure not to overlubricate the
unit as this might stain the floor or
carpeting where the unit stands.
18 Do not stand still on the belt while it
is moving.
19 In the event of any emergency, place
your feet on the side rails and hold onto
the handrail until the unit stops.
SAFETY INSTRUCTIONS.-
This product must have an earth
connection. In the event that the
appliance malfunctions then the earth
connection will redirect the electrical
current away from the machine and
reduce the risk of an electrical shock.
This product is supplied with a mains
cable that has an earth wire and a plug
with an earth pin. The plug must only
be used with an appropriate wall
socket, installed
connected to earth, in accordance with
local regulations.
DANGER! If the equipment is not
earthed correctly then there is a risk of
electrical shock. If in doubt, get an
electrician or technical specialist to
check that the earth connection is
treadmill and
avoid injury
correctly
correct. Do not modify the plug
when supplied with the equipment, if it does
not fit the wall socket then get an
electrician to install an electrical socket
that does.
This product must only be used on a
220-240 volt circuit, with an earthed
socket similar to that shown in Fig.A.
Make sure that the appliance is only
connected to a wall socket with the
and same pin layout as the plug. Do not
use an adaptor with this appliance.
Always
recommendations when using electrical
appliances:
1 Make sure that the mains supply
voltage matches that of the machine
before plugging it in. The supply
voltage must be the same as that
stated on the characteristics plate and
the holes in wall socket must match the
pins for plug on the machine. Do not
use any type of adapter.
2 To reduce the risk of electrical shock,
always unplug the unit immediately
after use and before proceeding to
clean it.
3 Only plug the machine into suitably
and
earthed wall sockets, as shown in Fig.
A. An inadequate electrical connection
may result in electrical shocks. If the
plug is not suitable for the wall socket
then change it for one that matches,
bearing in mind that the earth wire
must always be connected. If in doubt,
call technical services.
13
observe the following