BH FITNESS G6522 Instrucciones De Montaje página 14

Never leave the unit unattended when it
is plugged in. Unplug it after use.
5 Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6 Never use
recommended by the manufacturer.
7 Do not use the machine if the mains
cable becomes damaged or worn.
8 Keep the mains cable away from hot
surfaces.
9 Do not use the machine outdoors.
10 To unplug the machine, first put the
switch to the "0" position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect both
the electronic and electrical circuits.
This safety device will be automatically
triggered if the unit is subjected to
abnormal force or heat.
Should this occur:
1.- Set switch (L), located on the
casing, to the "0" (OFF) position Fig.B.
2.- Press the circuit button (C) to reset
the unit.
3.- Next, set switch (L) to the "I" (ON)
position and the unit will be ready for
use again.
Should the
repeatedly then the most probable
causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used,
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1].
accessories
circuit breaker
not
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.1.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(1) Main structure; (3) side bar (left);
(4) Side bar (right); (16) Allen screw
M8x25; (22) Self-tapping screw 4x16;
(23) Self-tapping screw 4x25; (33)
Monitor; (45) Safety key; (63) Side bar
base cover (Left); (64) Side bar base
cover (Right); (124) Allen key 6mm;
(127) Bottle of lubricant.
Follow the instructions step by step to
assemble:
1 First of all take the right side bar (4)
connect terminals (35) (36) Fig.2, then
trip
insert the side bar (4) into the bottom
right-hand support on the structure
and use screws (16).
2 Now take the left side bar (3) and
insert it into the bottom left-hand
support on the structure and use
screws (16) to secure it.
3 At least two people are needed for this
step. When fitting the side bars, one
person should hold the side bar while
the other one fits the screws (16). This
will prevent any possible accidents.
14
Fig.B