Sirius APPLIQUE SLT105 Instrucciones De Uso página 13

USES
The appliance can be arranged only for filte-
ring performances. In its filtering version the
air and fumes conveyed by the appliance are
cleaned both by a grease filter and by an ac-
tive coal filter, and put again into circulation.
INSTALLATION
At tge beginning make sure that the packa-
ge is intact and all the parts are unbroken,
otherwise stop the installation and contact
the dealer. The manufacturer is not re-
sponsible for damages caused by material
handling or product installation.
Before installing the appliance read all
these instructions carefully.
Take the wall bracket from the packaging
and install it, by means of using the provi-
ded screws and small blocks, as in figure 1.
It is possible to use the same bracket as a
template and draw the drilling to be done in
the wall.
Warning: before fixing the bracket it is ne-
cessary to pay attention to the following:
1 -The feeding cable must be inside the bra-
cket, as shown in fig. 2; 2 - The bracket must
be installed with a perfect horizontal axis in
regard to the floor, as in fig. 3; 3 - The wall
on which the product is installed must be ro-
bust enough, considering that the product as
a weight of approximately .... kilos.
Take the ducting product from the packa-
ging. Protect the installation pipe with some
paper sellotape, as shown in fig. 4.
Insert the wall plate, as shown in figure 5,
paying attention not to damage the finishing
of the pipe - protected with the paper sello-
tape, as described in the previous point.
Fix the product to the wall bracket, previously
installed, inserting the installation pipe in the
specific socket of the bracket, see fig. 6.
Clamp the product, using the provided screw,
inserting it as in fig. 7. Fix it all, using the
provided M6 nut.
In case the product proves to be not perfectly
perpendicular to the floor plan, it is possible
to do a further adjustment, securing the screw
indicated in fig. 8, to move the lower part of
the product away from the wall on which it
is installed (fig. 9). While securing the screw
(fig. 8), push the lower part of the product
from the bottom up to ease the adjustment.
Proceed with the electrical connection of the
product (fig. 16).
Place the cover on the wall plate (fig. 10), then
fix it with the two provided screws (fig. 11).
13