Ec Declaration Of Conformity - stayer LOM130PD Manual De Instrucciones

To remove the sandpaper:
1. Set the tool upside down so that the sandpaper is on top.
2. Grasping one corner of the sandpaper, peel it from the pad.
Note:
If the sandpaper is in good condition, save it for further use.
When sanding in narrow, hard-to-reach areas (e.g., shutters,
blinds, louvres), attach the cone-shaped abrasive papers to the
end of the pad (bottom and top). To sand the end of thin materials,
fold the abrasive paper and attach to the side of the pad as shown
in Fig. 4 and 5.
Tube powder collector (Fig. 7)
The use of the tube powder collector makes sanding operations
clean and dust collection easy. To attach the dust bag, fit the tube's
entry port onto the dust spout on the tool so that the hole in the
Switch action (Fig. 8)
CAUTION:
Always check to see that the tool is switched off before plugging in
the tool.
To start the tool, press the "ON (I )" side of the switch. To stop,
press the "OFF (O)" side of the switch.
Operation (Fig. 9 & 10)
Hold the tool firmly. Turn the tool on and wait until it attains full
speed. Then gently place the tool on the workpiece surface. A
finishing sander is generally used to remove only a small amount
of material at a time. Since the quality of the surface is more
important than the amount of stock removed do not bear down on
the tool.
Keep the base flush with the workpiece at all times. Excessive
pressure may damage the paper and shorten
tool life. You can put a high polish on furniture or other fine surfaces
by using a cloth under the tool.
For
This tool is handy for sanding louvres, etc. When sanding louvres,
insert the protruding portion of the pad between the louvres and
sand them using the upper or lower side of the abrasive paper.
CAUTION:
Do not block motor vent with your finger or hand.
Never run the tool without paper. You may seriously damage the
pad.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
To maintain product SAFETY and RELIABILITY, repairs, carbon
brush inspection and replacement, any other maintenance or
adjustment should be performed by a Stayer Authorized or
Factory Service Centers, always using Stayer replacement parts.
ENGLISH
9
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product is in
compliance with the following standards or standardized
in accordance with Council Directives, 2006/42/CE,
2004/108/CE and 2006/95/CE.
9
documents,
EN60745
Ramiro de la Fuente
Director General