Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
gb
4_OPERATING INSTRUCTIONS
OPERATION
Make sure that the power circuit voltage is the same
as that shown on the specification plata of the machine
and that switch is befare connecting the tool to the
power circuit.
Switching the machine on and off
Switch ON
Press the handle button next to the black safety but-
ton. Once the tool is switched on you may leave
the black safety button.
Switch OFF
Simply stop pressing the main handle button.
Press the rocker switch to the. After the machine has
been switched off, the sanding disc will still rotate far
a rime. Take care that parts of your body do not come
into contact with the disc and do not set the machine
down while it is still rotating!
TOOL CHANGE
Change of the disk
The abrasive disk can be easily changed thanks to the
fabric adhesion system (Velcro). Just pull the disc and
replace it with a new one.
NOTE: Only use sandpaper discs which fit properly
and which are designad far vacuum use.
Change of brush ring
The brush bristles on the edge of the sanding
plata cover serve two purposes, they keep the
sanding disc properly aligned with the work surface
without gouging and they also help the efficiency
of the dust collection by the vacuum cleaner.
These brush bristles will wear with continuad use.
The sanding plata cover should be replaced when the
bristles are too worn to ensure effective dust collection
and stabilization of the sanding head.
Replacement is the opposite of removal. Entrust all
repairs to an authorized service centre.
Remove the brush ring by removing the 8-star screws.
ADJUSTING OPERATION
Adjustment of the rotation speed
The speed of the machine is variable to suit different
tasks. lt can be adjusted from 1000 min·1 up to 1950
min·1 by using the thumb wheel. Turn in the counter
clockwise direction to increase the speed and in the
clockwise direction to decrease the speed. Generally,
you should use the higher speed far fast stock removal
and the lower speed far more precise control.
INSTRUCTIONS OF USE
Come usare questo apparecchio
Effective control of this powerful tool requires two-
handed tor maximum safety and control.
Always wear respiratory mask and glasses with EPI
level.
Once the machi ne and vacuum cleaner are set up
and all safety measures and equipment are in place,
begin by turning on the vacuum cleaner and then the
machine. (lf you are using a vacuum cleaner with
integrated switching, then simply turn the machine on.)
Begin sanding and carefully contact the work surface
as lightly as possible-just enough to keep the sanding
head flat against the surface.
The joist in the sanding head allows the sanding disc
to follow the contours of the work surface.
The best technique is to use overlapping sweeps and
keep the head in constant motion. Never stop too long
in any one place ar there will be swirl marks. With
experience it will be very easy to create excellent
results.
For a better job in the joints between walls and / or
ceilings, a part of the brush ring can be removed to
gain access to the 100% joint. To remove, release the
tab on the top of the sanding head to remove the part.
NOTE: Ensure that the sandpaper you are using
is suited to the task, overly coarse grit paper may
remove material too quickly to control. While overly
fine grit paper may clog too often and not shape down
the surface.
CAUTION: Take care to avoid sharp projections
and nails, etc.This will wipe out the sandpaper and
probably damage the sponge pad as well.
ELIMINATION
We recommend that the power tools, ac-
cessories and packaging should be a reco-
very process that respects the environment.
Only for EU countries:
Do not dispose of power tools into household
waste!
According to the European Directiva 2002/96/EC on
Waste Electrical and Electronic Equipment and its
implementation into national law, must accumulate
separately far power tools under an ecological
recycling.
Subject to modification.
-
8
-
Publicidad
Tabla de contenido
