Using For The First Time - VOX electronics FT-5410 Manual De Usuario

The Ready Light
The ready light will cycle on and off several times during frying. This indicates that the
temperature is thermostatically maintained.

USING FOR THE FIRST TIME

1. Remove all the packaging materials, labels and/or stickers from the deep fryer.
WARNING: Do not plug in the deep fryer when the control panel is not installed in
the deep fryer body. Only plug in the deep fryer when the unit is fully assembled and
the heating element is immersed in oil.
WARNING: Do not immerse the control panel, cord or plug in water.
WARNING: This unit should not be used to boil water.
2. Lift the control panel with heating element out of its slots by pulling it up from the
bottom with one hand while holding the body of the deep fryer with your other hand.
3. Remove the oil reservoir from the body of the deep fryer.
3. Wash the oil reservoir and the frying basket with hot water, a nonabrasive sponge, and
dishwashing liquid or other non-poisonous detergent. Dry thoroughly before use.
NOTE: The oil reservoir, frying basket, frying basket handle, permanent filter and the
lid can be washed in warm soap water.
WARNING: Do not immerse the control panel, power cord, or plugs into liquid of any
kind.
ASSEMBLING THE DEEP FRYER
1. Place the oil reservoir into the deep fryer housing.
2. Insert the guide edges on the control panel into the guide rails mounted on the metal
body
Slide
down
Guide
rails
Fig.1
4
(Fig.1).