Installation Of End Stops - SKYLOTEC SKYTAC Instrucciones De Uso

6.1.7 Installation of end stops

Detachable end stops:
Figure 6: Do not use grease!
Installation above the first rung in two holes of the guide rail
The securing plate must be located to the left of the climbing protection rail.
The arrow indicator points upwards (Fig. 4)
The bolt head of the fixing bolt is located on the inside of the guide rail
The self-locking nut is located on the rear side
The locking pin protrudes through the second hole in the rail
The locking pin is located under the fixing bolt
See Figure 6
Figure 7: Tighten DIN 439 nuts medium-tight with bolt adhesive (such as Würth 08932430XX with a
breakaway torque ~ 21 Nm) and install, together with the DIN 125 washer from the front through the rail,
using an appropriate box wrench (SW 19) by hand!
The bolt adhesive ensures that the nut will not work loose.
After assembly, the top of the nut must be flush with the first offset of the latching pin.
Installation
detachable end stops
TAC-0050
Carriage
M12x30
Nut DIN439-M12-A2
U-disk DIN125-A-13-A2
Figure 6: Overview of detachable end stops
Figure 7: Assembly of nuts and installation position
Installation on the front of the guide rail in the top slot. The upper edge of the end stop is flush with the top
of the climbing protection rail. Mounting bolt blocks the guide rail, the bolt head is located externally on the
stop and the self-locking nut is on the back
MAT-MA-0035_GB SKYTAC
of the
bolt
Version as of: 13/02/2018
Nut DIN985-M12-A2
U-disk DIN125-A-13-fz
Locking pin
A2 corner with welded nut
page 10 of 37