Equipment Disposal - OHAUS ISRK04HDG Manual De Instrucciones

i
nStallation
Upon receiving your Ohaus Rocker/Waver, check to ensure that no damage has
occurred in shipment. It is important that any damage that occurred in transport is
detected at the time of unpacking. If you do find such damage the carrier must be
notified immediately.
After unpacking, place the Rocker/Waver on a level bench or table, away
from explosive vapors. Ensure that the surface on which the unit is placed will
withstand typical heat produced by the unit and place the unit a minimum of six (6)
inches from vertical surfaces. Always place the unit on a sturdy work surface.
The Rocker/Waver is supplied with a power cord that is inserted into the IEC
connector on the back of the unit first, then it can be plugged into a properly grounded
outlet. The 120V unit plugs into a 120 volt, 50/60 Hz source. The 230V unit plugs into
a 230 volt, 50/60 Hz source.
m & S
aintenance ervicing
The Rocker/Waver is built for long, trouble-free, dependable service. No lubrication
or other technical user maintenance is required. However at least every three (3)
months you should:
• Unplug the unit.
• Remove any accumulated dirt from the base and tray.
• Check all accessible items to make sure they are properly tightened.
The unit should be given the care normally required for any electrical appliance. Avoid
wetting or unnecessary exposure to fumes. Spills should be removed promptly. DO
NOT use a cleaning agent or solvent on the front panel or lid which is abrasive
or harmful to plastics, nor one which is flammable. Always ensure the power is
disconnected from the unit prior to any cleaning. If the unit ever requires service,
contact your Ohaus representative.
i U
ntended Se
These Rockers and Wavers are intended for general laboratory use.
e c - i
nvironmental onditionS
Operating Conditions: Indoor use only.
Temperature: 5 to 40°C (41 to 104°F)
Humidity: 80% relative humidity, non-condensing
Altitude: 0 to 6,562 ft (2000 M) above sea level
Non-Operating Storage:
Temperature: -20 to 65°C (-4 to 149°F)
Humidity: maximum 80% relative humidity, non-condensing
Installation Category II and Pollution Degree 2 in accordance with IEC 664.

eQUiPment diSPoSal

This equipment must not be disposed of with unsorted waste. It is your
responsibility to correctly dispose of the equipment at life-cycle-end by
handing it over to an authorized facility for separate collection and recy-
cling. It is also your responsibility to decontaminate the equipment in case
of biological, chemical and/or radiological contamination, so as to protect
the persons involved in the disposal and recycling of the equipment from health hazards.
For more information about where you can drop off your waste of equipment, please
contact your local dealer from whom you originally purchased this equipment. By doing
so, you will help to conserve natural and environmental resources and you will ensure that
your equipment is recycled in a manner that protects human health.
r W
ncUbating ockerS and averS
EN
2