En Troubleshooting - JVC GR-DA30U Manual De Instrucciones

32
Troubleshooting
EN
Problem
The tape is moving, but
there is no picture.
Blocks of noise appear
during playback, or
there is no playback
picture and the screen
becomes blue.
Data battery status
does not appear.
Warning Indication
High
Exhausted
SET TO MANUAL
MODE
TAPE END
LENS CAP
SET DATE/TIME!
CHECK TAPE'S
ERASE PROTECTION
TAB
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
OR DC PLUG
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can
resume using the camcorder. If the indication remains, consult your nearest JVC dealer.
Possible Cause
• Your TV has AV input terminals,
but is not set to its VIDEO mode.
• The cassette holder cover is open.
• The AC Adapter is connected to
the camcorder.
• The camcorder turned off
automatically.
• Displays the battery remaining power.
• As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns off
automatically.
• Appears when you attempt to change "Menu Settings", "Backlight
Compensation" or "Manual Focus" while in AUTO mode A. (
• Appears when the tape ends during recording or playback.
• Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
• Appears when the date/time is not set.
( 12).
• The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
• Appears if a tape is loaded while the Power Switch is set to "REC".
• Blinks when no tape is loaded.
• Appears when the erase protection tab is set to "SAVE" while the Power
Switch is set to "REC".
• Error indications 01, 02 or 06.
Remedy: Remove and reattach the power supply or battery.*
• Error indications 03 or 04.
Remedy: Eject the cassette and reinsert.*
Set the TV to the mode or channel
appropriate for video playback.
( 18)
Close the cassette holder cover.
( 13)
Clean the video heads with an
optional cleaning cassette.
( 2)
Disconnect the AC adapter from
the camcorder.
Turn the camcorder off, then on
again.
Meaning / Remedy
Remedy
9)