Metabo HPT CR 18DA Manual De Instrucciones página 14

English
Mounted in the same manner as a reciprocating saw
blade. Make sure that the shank of the blade is fi tted
into the center cavity. (Fig. 11)
Slit
Blade
Pull the back of the saw blade two or three times by
hand and check that the blade is securely mounted.
4. Dismounting the blade
CAUTION
Never touch the saw blade immediately after
use. The metal is hot and can easily burn your
skin.
(1) After turning the blade holder, point the blade
downward. The blade should fall out on its own. If the
blade fails to fall out, pull it out by hand. (Fig. 12)
Blade
WHEN THE BLADE IS BROKEN
Even when the saw blade is broken and remains
inside the small slit of the blade holder, it should fall
out when the blade holder is turned and the blade is
pointed downward. If the blade fails to fall out on its
own, take it out by using the procedures described
below.
(1) If a part of the broken saw blade is sticking out of the
small slit of the blade holder, pull out the protruding
part and take the blade out.
(2) If the broken saw blade is hidden inside the small
slit, hook the broken blade using a tip of another saw
blade and take it out. (Fig. 13)
14
Fig. 11
Blade holder
Fig. 12
Another blade
MAINTENANCE AND INSPECTION OF SAW BLADE
MOUNT
(1) After use, blow away sawdust, earth, sand, moisture,
etc., with air or brush them away with a brush, etc., to
ensure that the blade mount can function smoothly.
CAUTION
Do not use any saw blade with a worn-out blade
hole. Otherwise, the saw blade can come off ,
resulting in personal injury. (Fig. 14)
Blade
5. Adjusting the base
To maximize blade life, the base slides in or out
to allow the stroke length to be adjusted for better
effi ciency. (Fig. 15)
Pressing the base lock button will allow the base to
be adjusted forward or back.
The base is fi xed in position when you hear a "click".
(Fig. 15)
Base
Blade holder
Slit
Fig. 13
Blade hole
Fig. 14
Base lock button
Fig. 15