Starmix T 500 Instrucciones De Montaje página 10

Features:
Electronic short-duration timer
Timer running time 32 sec.
Electronic short-duration timer
Timer running time approx. 4 min.
Electronic infared proximity switch
Without switching facility (for coin-operated
timer MZS 4)
Safety mains connection
Safety temperature limiter
Safety sensor switch-off
Thermal safety fuse
Integrated mounting plate
Theft-proofing cover plate
Air-inlet grille, cleanable by suction
4. Mounting instructions.
The appliance must be installed by a specialist to ensure
that the requisite safety rules for the connection of electrical
appliances are observed. In rooms with showers and baths
the appliance must not be installed within the safety areas
set forth in the VDE German standard (0.6 m from the edge
of showers or baths, and 1.2 m from shower heads).
The electrical wiring must incorporate a switch with a
contact opening of > = 3 mm for all-pole disconnection of the
appliance.
5. Mounting sequence.
The service friendly mounting concept
The T 500 mounting system ensures simple wall installation
without having to open the appliance. For reasons of
practicality the appliance is subdivided into 2 sections.
The electrician must first install a socket outlet (or a perma-
nent connection), then screw the mounting plate to the
wall, slide the ready-to-operate appliance onto the
plate, plug the power supply cable into the socket (or
connect the permanent wiring), screw the anti-theft plate
onto the appliance – and that's it. It just couldn't be easier!
1. Pull the cover plate 1 (which is not screwed tight)
down out of the appliance.
10
T 500 T 500 E TH 500
X
X
X X
X X
X
X X
X X
X X
X X
The mounting plate 2 inserted in the back of the
appliance is likewise pulled down.
2. After having determined the point of installation, mark
out the 4 mounting holes w using the mounting plate
2 as a template for this purpose, and then drill 8 mm
diameter holes. Insert the dowels and fasten the
mounting plate with the 4 supplied wood screws. The
appliance should be mounted at a level indicated in
figs. A, B or C. The appliance must be firmly mounted on
a solid wall.
3. The 5 subsequently described methods of connection
are possible.
3.1 Connection by way of flush-mounted socket:
The top part of the cover plate 1 is not required. Break
it off at the predetermined breaking point 4. Fasten the
mounting plate 2 as indicated in fig. B, push the
appliance from above onto the mounting plate, plug the
power supply cable into the socket outlet 3, and push
the appliance all the way down. Fasten the cover plate
with the 2 supplied countersunk sheet metal screws.
3.2 Connection by way of concealed wiring:
Connect with the concealed wire 7 coming out of the
wall (in place of the socket). Fasten the mounting
plate 2 to the wall as indicated in fig. C. Push the mount
plate from underneath into the mounting plate. Conduct
the wire coming out of the wall through the hole in the
TH 500 Z TH 500 E
X
X
X X
X X
X X
X X
X X
X X
X
X
X
X
X
X
X
X