Simpson MS60753 Manual De Instrucciones página 5

qUICk SETUp GUIDE
WARNING: To reduce the risk of injury, read the pressure washer instruction manual and
the engine instruction manual before operating pressure washer.
Install the handle
B
a
Place handle onto
frame, depress
the snap buttons, and
oil. Before starting engine,
slide the handle assembly
add the oil provided.
onto the frame until snap
Check oil level prior to
buttons snap into place.
each use. Refer to Engine
Owner's Manual for
complete procedure.
IMPORTANT: Ethanol Shield (sold separately) is a fuel stabilizer that helps eliminate
TM
and prevent ethanol related problems in power equipment. Follow the instructions on the
container and add to the gasoline.
qUICk START GUIDE
DANGER:
• Never run engine indoors or in enclosed, poorly ventilated areas. Engine exhaust
contains carbon monoxide, an odorless and deadly gas.
• Risk of fluid injection and laceration. When using the high-pressure setting, DO NOT
allow the high-pressure spray to come in contact with unprotected skin, eyes or with
any pets or animals. Serious injury will occur.
Connect Garden
1 2
hose to Pump
Thread the garden
hose to the pump inlet. Connect the high pressure
hose to the pump outlet.
See label #1 on unit.
See label #2 on unit.
Add/Check Oil Add Gasoline
c
In a well ventilated
The engine is
shipped without outdoor area
add fresh, high quality,
unleaded gasoline with a
pump octane rating of 86
or higher. Do not overfill.
Wipe up spilled fuel before
starting the engine. Refer to
Engine Owner's Manual
for complete procedure.
Connect high Connect high
3
Pressure hose to Pressure hose to
Pump Spray Gun
Thread the other end of
the high pressure hose
to the spray gun.
8- ENG
Connect Spray
4 5
Wand to Spray
Gun
Thread the spray wand into
Rotate the spray selector to
the end of the spray gun.
the desired setting
Release Air from
8
7
System
Release all air from
See label #8 on unit.
pump and high pressure
hose by depressing
trigger until a steady
stream of water is present.
Approximately 30 seconds.
30 S
Move the Choke to
10
the CLOSED Position
Pull the recoil
See label #10 on unit.
starter grip to start
the engine.
See label #11 on unit.
WARNING: This Guide is not a substitute for reading the operator's manual. User must
read and understand operator's manual before using this product.
Select a spray Turn Water
6
pattern faucet
Completely On
Do not run the unit
without water supply
connected and turned on.
Use Cold Water Only.
Verify the Engine
Verify the fuel
9
Switch is turned
Switch is in the
to the ON
ON Position
Position
See label #9 on unit.
Pull the Move the
11 12
Recoil Starter Choke to the
Grip OPEN Position
Gradually move
the Choke to the
OPEN Position after
engine starts.
See label #12 on unit.
9 - ENG