Specifications - General DT8852 Manual Del Usuario

data logging package is to renumber the COM ports that represent
your PC's USB jacks; the application can only stream data to COM
ports assigned a number between 1 and 4.
To enable long-term data logging, you must disable the thermometer's
Auto Power Off (APO) feature. If you do not, the instrument will
automatically power off after 20 minutes of front-panel inactivity. To
disable APO, power the thermometer off and then power it back on in
the following special way: Press and hold the REL/HOLD button before
pressing the
appear on the LCD. Two seconds later, the "n" will disappear and the
instrument will power on normally—but with the APO function
disabled. There is no display indication of APO status (whether the
function is enabled or disabled).

SPECIFICATIONS

Maximum Measurement Ranges
-328° to 2498°F (-200° to 1370°C) with "K" type thermocouple(s)
-328° to 1400°F (-200° to 760°C) with "J" type thermocouple(s)
-328° to 734°F (-200° to 390°C) with "T" type thermocouple(s)
32° to 1832°F (0° to 1000°C) with "R" type thermocouple(s)
32° to 3200°F (0° to 1760°C) with "S" type thermocouple(s)
-328° to 1357°F (-200° to 736°C) with "E" type thermocouple(s)
Measurement Accuracies (from 64° to 82°F)
±(0.1% of reading + 1.4°F (0.7°C)) with "K", "J", "T" and "E" type
thermocouple(s)
±(0.3% of reading + 1.4°F (0.7°C)) with "R" and "S" type
thermocouple(s)
Measurement Resolution
0.1° (F or C) below 1000°; 1° (F or C) above 1000°
Measurement Range of Included Thermocouple(s)
-58° to 392°F (-50° to 200°C)
Auto Power Off Trigger
Operating Temperature
Dimensions
Weight
Power Source
1
button. Doing so will cause a large, lower-case "n" to
20 minutes of front-panel inactivity
32° to 122°F (0° to 50°C) @<85% RH
7.16 x 2.83 x 1.18 in. (182 x 72 x 30mm)
7.8 oz. (220g)
One "9V" battery (included)