Electrical Connections - baltur TBG 1100 ME Manual De Instrucciones

Every time the burner has to be opened, it is necessary to
disconnect gas solenoid valves connectors first.

ELECTRICAL CONNECTIONS

It is recommended that all connections are performed with electrical
flexible wires.
• Power lines must be outdistanced from the hot parts.
• Make sure that the electric line to which the unit will be connected
has frequency and voltage ratings suitable for the burner.
• Make sure that the main line, the relevant switch with fuses
(essential) and the possible limiter are suitable to stand the
maximum current absorbed by the burner.
• For the mains supply connection is required an ominpolar switch
with a contact opening gap equal or above 3 mm in accordance
with current safety regulations.
• Remove the external insulating seal of the supply pipe necessary
for the connection, preventing the cable to touch metal parts.
• For details, refer to the specific electric diagram for every burner.
9 / 22
0006160030_201306
fig.3