Technical Specifications - baltur TBG 1100 ME Manual De Instrucciones

TECHNICAL SPECIFICATIONS

THERMIC POWER
OPERATION
NOx EMMISION
MOTOR
ELECTRICAL POWER ABSORBED*
IGNITION TRANSFORMER
VOLTAGE
PROTECTION RATING
FLAME DETECTION
ACOUSTIC PRESSURE**
ACOUSTIC POWER ***
WEIGHT WITHOUT PACKAGING
NATURAL GAS (G 20)
FLOW RATE
PRESSURE
SUPPLIED MATERIAL
INSULATING SEAL
STUD BOLTS
HEXAGON NUTS
FLAT WASHERS
*) Total absorption at start with ignition transformer on.
The measurement has been carried out in Baltur's laboratory, in accordance with EN 15036-1 standard
** Acoustic pressure measured one meter behind the equipment, it refers to Baltur's laboratory environment conditions and cannot be compared to measurements
carried out in different locations, with burner running at maximum rated thermal capacity.
*** Acoustic pressure was obtained characterizing Baltur's laboratory with a sample source, this measurement has an accuracy of class 2 (engineering class) with a
standard deviation f 1.5 dB(A).
**) Acoustic pressure measured in the laboratory of the manufacturer with burner running on test boiler, at maximum rated heating capacity
MAX kW
MIN kW
PROGRESSIVE / ELECTRONIC MODULATING TWO STAGE
mg/kWh
50 Hz
.
50 Hz
kW
50 Hz
dBA
dBA
kg
MAX m³n/h
MIN m³n/h
MAX mbar
5 / 22
0006160030_201306
TBg 1100 me
11000
1000
Class II (<120 mg/kWh)
22 kW - 2940
rpm
23
8 kV - 30 mA – 230 V / 50 Hz
3N ~ 400 V ±10%
IP 54
IONISATION ELECTRODE
89.4
98.6
315
1106
101
500
TBg 1100 me
2
N° 4 M 20
N° 4 M 20
N° 4 Ø 20