Trial Fitting - Ottobock 8066 Instrucciones De Uso

The initial fitting and application of the product must be carried out by qualified personnel
►
according to the instructions of the treating physician.
Consult a physician if any exceptional changes are noted (such as worsening of the com­
►
plaint).
5.1 Size selection
The product is available in a universal size.
The length can be adapted to the leg using the telescoping bars (see fig. 5).
5.2 Adaptation
The initial fitting must be carried out by trained, qualified personnel.
Adapting the telescoping bars to the leg length
> The product has been applied to the patient.
► To adapt the telescoping bars to the patient's leg length, turn the gear wheel between the
thigh and lower leg sleeves.
Adjusting the flexion angle
1) Slide the release button up and hold it in position.
2) Turn the adjustment wheel to set the desired flexion angle, 1. flexion or 2. extension, on the
sliders.
3) Let go of the release button to lock the chosen position. CAUTION! Make sure the setting
is the same for both orthotic joints.
5.3 Application
CAUTION
Incorrect or excessively tight application
Risk of local pressure and constriction of blood vessels and nerves due to improper or excess­
ively tight application
Ensure that the product is applied properly and fits correctly.
►
NOTICE
Use of a worn or damaged product
Limited effectiveness
Before each use, check the product for functional reliability and for possible wear or dam­
►
age.
Do not continue using a product that is no longer functional, or that is worn or damaged.
►
> All straps on the orthosis are opened.
1) Pass the thigh and calf pads around the leg and fasten them with the hook-and-loop closures
at the front of the leg.
2) Position the lateral orthotic joint at the height of the middle of the patella and secure it to the
pad with the hook strap on the back of the splint.
3) Repeat this step for the medial orthotic joint. CAUTION! Adjust the orthosis so the splints
are parallel to each other and the medial and lateral orthotic joints are at the same
height.
4) Pass the straps through the strap guide loops. Close the straps first below and then above
the patella. Make sure that the hook-and-loop sections are placed over one another.
→ The orthosis should fit firmly but is still comfortable to wear.

5.4 Trial fitting

► Check that the orthosis is fitted properly on the leg before handing over to the patient.
10