Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
The luminaire does not switch on automatically via the motion
sensor.
Possible causes:
• The luminaire was switched off via push-button.
Please note: After switching off the luminaire, motion detec-
tion only becomes active again when no people were in the de-
tection range for a longer time period than the set delay time.
• The workstation is not completely located in the detection
range of the sensors.
Move your hand in front of the sensor and observe the lumi-
naire behaviour. If the luminaire does not respond to the
motion, realign the luminaire.
• Sufficient daylight is available - additional artificial light is
not required.
30
Sommaire
Page
32
33-39
40-43
44-45
31
Publicidad
Capítulos
Tabla de contenido
