Setting Up The Wireless Connection; Inserting Batteries Into The Manual Control - Trilux EDS+RF Serie Instrucciones De Manejo

Manual group functions
Luminaires combined to a group (room) or sub-group (zone)
can be commonly operated via wireless remote control.
The following operating functions are possible:
• Lighting group switched on or off with the "On" or "Off"
button.
• Lighting group dimmed to desired level by touching the
"brighter/darker" ring. The dimming level increases from
bottom left to bottom right in a clockwise direction.
• Call one of three light scenes by touching the corresponding
push-button (see figure, page 25).
Note: With manual dimming or calling a light scene, the
daylight-dependent control of all affected luminaires is deacti-
vated for the time until they are switched off and on again.
Selecting a zone
• Press and hold the "back" or "continue" button for three
seconds.
• A confirmation tone is heard. The lamp symbol lights up.
• Select the desired zone with the "continue" and "back"
button.
• Now switch and dim the selected zone with the "On" and
"Off" buttons and the "brighter/darker" ring (see figure,
page 25).
Saving a light scene
To create and save a new light scene proceed as follows:
• Select all the zones consecutively and switch and dim these
to your desired level.
• Press one of the scene buttons until you hear a confirmation
tone.
• The light scene is now saved. The previously saved light
scene is permanently deleted.
24

Setting up the wireless connection

Setting up the wireless connection is via the manual control
LMS Acti UID 8410 (TOC 63 116 00).
back
off
scene 1
(with feedback)
scene 2
(with feedback)

Inserting batteries into the manual control

• To open the manual control press the button on the front
(see point 1).
• Remove the rear cover (see point 2).
• Insert three batteries (AAA) according to the designations (+)
and (-) (see point 3).
• The manual control signals readiness with a
confirmation tone.
3
on
continue
scene 3
(with feedback)
1
2
25