Removing Manual Control, Reset Function; Troubleshooting - Trilux EDS+RF Serie Instrucciones De Manejo

Removing luminaires, reset function
Deleting a luminaire
To remove a luminaire from the group, proceed as follows:
• Activate programming mode
(press "Scene 1" and "On" buttons simultaneously (see
above, page 26)).
• Press the "Scene 1" button.
• The "Scene 1" button and the lamp symbol light up.
• The lamp symbol and the luminaire flash.
• Press the "Off" button on the manual control while the lumi-
naire flashes.
• The lamp symbol changes from flashing to continuous light-
ing.
a: • The luminaire dims to a minimum (removed).
b: • A negative confirmation tone is heard
(not removed).
• The lamp symbol and a further luminaire start to flash.
• Repeat this process for the other luminaires you wish to
remove.

Removing manual control, reset function

• Open the manual control (see figure, page 25).
• Press and hold the reset button for 3 seconds.
• A positive confirmation tone is heard.
All information saved in the control device has been perma-
nently deleted.
28
reset

Troubleshooting

The luminaire does not function.
Possible causes:
• The luminaire was switched off via the push-button.
Switch the luminaire on.
• The light sources are defective.
Contact TRILUX with defective lamps.
• The sensor is excessively exposed to ambient light.
Cover the sensor and observe luminaire behaviour.
• No mains power exists.
Check whether mains power is available.
The luminaire does not regulate brightness to the set nominal
value.
Possible causes:
• Brightness control is deactivated.
Set the function selection switch to Position II.
• Brightness control has been set to a very high nominal
value.
Set the nominal value.
• Brightness control has been deactivated by changing the
brightness with the button.
Switch the luminaire off and on again.
29