Checking Gas Pressure - Angelo Po 0G1FR3G Manual De Uso

To carry out this operation, proceed as follows.
1 - Switch the appliance off and leave it to cool
(see page 10).
2 - Turn off the gas supply tap.
3 - Remove and clean the baskets and the basket
support structure (A).
4 - Drain and filter the oil (see page 11).
5 - Apply a food-grade detergent to the inside of
the well.
6 - Rinse the well with drinking water and drain.
7 - Apply a specific product or a water and vinegar
solution to the well to remove the detergent res-
idues.
8 - Rinse, empty and dry the well.
9 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
To carry out this operation, proceed as fol-
lows.
1 - Turn off the gas supply tap.
2 - Open the hatch (A).
IT
IT
3 - Undo the screw (B) of the pressure connection.
4 - Connect the pressure gauge (C) to the pres-
sure test point.
GB GB
5 - Turn the gas supply tap back on.
6 - Use the knob (D) to light the burner (see page
DE DE
10)
7 - Turn the knob (E) to the full flame setting then
FR FR
check that the pressure reading complies with
the values provided in the table at the back of
the manual.
ES
ES
8 - Switch off the burner, turn off the gas supply tap
and disconnect the pressure gauge.
9 - Restore the initial conditions after completing
the operation.
English
CLEANING WELL, BASKETS AND BASKET SUPPORT STRUCTURE

CHECKING GAS PRESSURE

A
E
A
- 14 -
IDM-39603311300.tif
C
B D
IDM-39603311100.tif