Main Menu; General Warnings - Dal Zotto Leyla Elite Manual Del Usuario

MAIN MENU

2 1
2 1
3
3
FRONT AIR
DUCTING
EASY SETUP
CHRONO
SETTINGS
*STOVE STATUS
*MENU
TECHNICIAN

GENERAL WARNINGS

Advice to follow for the rst start-ups of the product:
During the rst hours of operation, there may be some smoke or
odours, but they are due to the normal "thermal break-in" process.
During this process, the duration of which changes depending on
the product, it is recommended to:
Š Ventilate the room well
Š If present, remove any majolica parts from the top of the
product
Š Activate the product at the maximum power and temperature
Š Avoid remaining in the room for a long time
Š Do not touch the surfaces of the product
Notes:
The process is completed after a few heating/cooling cycles.
Do not use for the combustion of elements or substances other than
those indicated in the manual.
MAKE SURE THAT THERE ARE NO RESIDUES OR DIRT AT THE BOTTOM
OF THE BURN POT. THE HOLES AT THE BOTTOM MUST BE COMPLETELY
CLEAR, TO ENSURE PROPER COMBUSTION.
FUNCTION CAN BE USED TO ADAPT COMBUSTION ON THE BASIS OF THE
NEEDS DESCRIBED.
6 4
6 4
OFF
SET
DATE TIME
LANGUAGE
DISPLAY
STAND BY
DELTA T
FIRST LOAD
DEGREES
RESET
1 Back - exit
2 3
Scroll through parameters: next (3); previous (2)
Change settings data: increase (4); decrease (5)
4 5
5
Con rm - access Menu
6
5
ENABLING
PRG1
PRG2
PRG3
PRG4
Before turning on the product, it is necessary to perform the
following checks:
Š If it is intended to be connected to a hydraulic system, it must
be complete and fully functional and in compliance with the
instructions given in the product manual and with the relevant
regulations in force.
Š The pellet hopper must be completed loaded
Š The combustion chamber and the burn pot must be clean
Š Make sure that the re holder, the ash pan and the pellet
hopper close hermetically (if present in the hermetic version); they
must be closed and there must be no foreign bodies in the sealing
elements and gaskets.
Š Check that the power cord is properly connected
Š The bipolar switch (if present) must be set to position "1".
THE "EASY SETUP"
ENGLISH
SET
SET
*TECHNICIANS ONLY
BURN POT BOTTOM
51