Front Air; Ducting; Easy Setup - Dal Zotto Leyla Elite Manual Del Usuario

FRONT AIR

This menu allows you to set the front air motor speed. Range: (comfort, auto).
If you select comfort mode, the front air speed is reduced.
To ensure combustion e ciency, the front air is excluded when the product is at the minimum power.
CONTROLS PROCEDURE
Š Press 6.
Š Con rm FRONT AIR by pressing 6.
Š Use keys 4 -5 to set the desired mode.
Š Press 6 to con rm or 1 to return to the previous menus to the initial state.

DUCTING

This menu allows you to set the ducting motor speed. Range: (o , comfort, auto).
If you select comfort mode, the front air speed is reduced. If you select o mode, the ventilation will turn o if the temperature of the fumes
is within certain limits.
CONTROLS PROCEDURE
Š Press 6.
Š Press 3 until DUCTING appears and con rm by pressing 6.
Š Use keys 4 -5 to set the desired mode.
Š Press 6 to con rm or 1 to return to the previous menus to the initial state.

EASY SETUP

The volumetric weight of the pellet is the ratio between the weight and the volume of the pellet. This ratio may change while keeping
the quality of the pellet unchanged. Use the EASY SETUP function to change the calibration of the volumetric weight by increasing or
decreasing the preset values.
In the stove program, the available values from "- 3" to "+ 3"; all stoves are calibrated in production with the optimal value which is 0.
If you notice an excessive deposit on the burn pot, enter the EASY SETUP program and reduce the value to "- 1"; then wait the following day
and if you do not see an improvement reduce it even more up to a maximum of "- 3".
If, on the other hand, it is necessary to increase the calibration of the volumetric weight of the pellet, switch the factory value from "0" to "+
1, + 2, + 3" as required.
EXCESSIVE PELLET DEPOSIT IN THE BURN POT
-3 -2
THIRD SECOND
DECREASE DECREASE
RANGE IF THE RANGE IF THE
FIRST TWO ARE FIRST IS NOT
NOT ENOUGH ENOUGH
CONTROLS PROCEDURE
Š Press 6.
Š Press key 3 until EASY SETUP appears and con rm by pressing key 6.
Š Use keys 4 -5 to set the range.
Š Press 6 to con rm or 1 to return to the previous menus to the initial state.
N.B.: IF THIS CALIBRATION DOES NOT SOLVE THE PELLET DEPOSIT IN THE BURN POT, PLEASE CONTACT YOUR LOCAL
SERVICE CENTRE.
54
NORMAL OPERATION
-1
FIRST DECREASE
OPTIMAL FACTORY
RANGE (TEST
VALUE
FOR 1 DAY)
ENGLISH
MINIMUM PELLET DEPOSIT IN THE BURN POT
0 +1
FIRST INCREASE
RANGE
+2 +3
SECOND
THIRD INCREASE
INCREASE
RANGE IF THE
RANGE IF THE
FIRST TWO ARE
FIRST IS NOT
NOT ENOUGH
ENOUGH