Assembly Appliances In Banks; Electrical Connection - Angelo Po 0G1FT2E Manual De Uso E Instalación

To assemble appliances in banks (side by side)
proceed as described below.
1 - Pull off the knob (A).
2 - Undo the screws and remove the control
panels (B).
3 - Apply masking tape to the edges to be placed
side by side.
4 - Apply food-approved sealant to the edges to be
placed side by side.
5 - Place the appliances side by side.
6 - Connect the appliance using the screws and
nuts (C-D).
7 - Remove the excess sealant and the masking
tape.
8 - Apply the sealant to the inside of the lid (E), and
fit it to cover the fixing zone.
9 - Replace the control panels (B) and the knobs (A)
on completion of the operation.
A variety of optional installation kits are avail-
able for arranging appliances in banks:
G)"Bridge" installation kit
IT
Important
GB
The connection must be made by author-
ised, skilled personnel, in accordance with
DE
the relevant legal requirements, using ap-
propriate and specified materials. The ap-
pliance is supplied with operating voltage
FR
400V/3N, which can be switched to 230V/3.
ES
Caution - warning
Before doing any work, cut off the mains elec-
tricity supply.
Connect the appliance to the mains electricity sup-
ply as follows.
1 - If not already present, install a circuit-breaker (A)
with overload cutout and differential safety
breaker close to the appliance.
2 - Undo the screws (B) and remove the guard (C).
3 - Connect the circuit-breaker (A) to the terminal
board (D) of the appliance as shown in the dia-
gram and in the electrical system diagram at
English

ASSEMBLY APPLIANCES IN BANKS

ELECTRICAL CONNECTION

A
B
C
A
C
the back of the manual. Use a cable with at
least H05RN-F characteristics.
Important
When connecting, take care to connect the
neutral and earth lines.
4 - Replace the guard (C) and retighten the screws
(B).
- 14 -
E
D
G
B
D
IDM-396013401400.tif