Safety Instructions Related To The Product And Technology - Aventics DDL Instrucciones De Servicio

During assembly
Commissioning
During operation
AVENTICS | SERCOS III | R412012613–BDL–001–AC
2.6 Safety instructions related to the product
and technology
W
The bus coupler (electrostatically endangered components)
may only be opened by trained personnel.
W
Make sure the relevant system component is not under
pressure or voltage before assembling or when connecting
and disconnecting plugs. Protect the system against being
switched on.
W
Only use a power pack with safe isolation in accordance with
DIN EN 60742, classification VDE 0551 for the power supply.
Please pay attention to external fuses that comply with this
description
W
The warranty will not apply if the product is incorrectly
assembled.
W
Always assemble the bus coupler on a mounting plate or in
a control cabinet.
W
Observe the installation position described in the operating
instructions.
W
Lay the cables so that no one can trip over them.
W
Other system parts may be damaged by uncontrolled device
movements if it has not been properly mounted. Make sure
that the device is securely fastened.
W
Ground the devices according to national regulations.
W
Only use cables indicated in the operating instructions or
quotation drawings.
W
Installation/assembly and commissioning of the device may
only be carried out in a voltage-free and pressure-free state
by trained and qualified specialists.
W
Only put the device into operation if it has been completely
assembled, correctly wired and tested.
W
Switch off the power supply before connecting or
disconnecting plugs to avoid damaging the electrical parts.
W
Observe related safety notes in the operating instructions.
47
Notes on Safety