GB
(RE) PROGRAMMING WHEEL LOCATIONS
Deflate Right Rear tire by more than 3 PSI (0,2 BAR).
8
The RR sensor is programmed when a confirmation
beep tone sounds. Display shows 004
Deflate Left Rear tire by more than 3 PSI (0,2 BAR).
9
The LR sensor is programmed when a confirmation
beep tone sounds.
Display shows 4 tire location LED's
To program 2 additional wheel sensors for 6 wheel
vehicles Proceed to step 10
Display dims after 1 minute and exits set up mode
4 4 9 9
Push and hold Check button for 3 seconds until
10
1st audible beep tone sounds. Display shows 005.
11
Deflate Right Outer Rear tire by more than 3 PSI (0,2
BAR). The RIR sensor is programmed when a confir-
mation beep tone sounds. Display shows 006
Deflate Left Outer Rear tire by more than 3 PSI (0,2
12
BAR). The LIR sensor is programmed when a confir-
mation beep tone sounds. Display dims after 1
minute and exits set up mode
A
A
A
A
A