Hella TC-400 Instrucciones De Montaje página 48

GB (RE) PROGRAMMING WHEEL LOCATIONS
1 Press and hold Check button on display.
Turn on ignition
2
Release Check button when display shows Ln5
3
To program Spare Wheel sensor Proceed to step 4
To disregard Spare Wheel sensor Proceed to step 5
Deflate Spare Tire by more than 3 PSI (0,2 BAR). The
4
Spare Wheel sensor is programmed when a confirmation
beep tone sounds.
4 4 8 8
Display shows 001. Proceed to step 6
To disregard Spare Wheel sensor, push and hold Check
5
button for 3 seconds.
Display shows 001.
Deflate Left Front tire by more than 3 PSI (0,2 BAR). The
6
LF sensor is programmed when a confirmation beep tone
sounds. Display shows 002.
Deflate Right Front tire by more than 3 PSI (0,2 BAR). The
7
RF sensor is programmed when a confirmation beep tone
sounds. Display shows 003.
0 1
0 1
A
A
A