Hella TC-400 Instrucciones De Montaje página 50

SET STANDARD PRESSURE
GB
& WARNING LEVELS
Inflate all tires to the prescribed pressures as
1
indicated in vehicle service manual or on the
pressure placard attached to vehicle.
2 Press and hold Check button on display.
Turn on ignition
3
5 5 0 0
Release Check button when display shows
4
Flashing Tire Positions
The Positions will flash On/Off until all sensor data
5
has been recieved. An audible beep tone confirms
that your standard tire pressure level has been
programmed.
Display will show all Positions during a period 1
6
minute before switching off. To adjust system
warning levels, proceed to Step 7 within max. 1
minute!
v 160km/h
Bar/psi/kPa
1-3 4 1-3 4
155/70R13 2,3/33/230 2,5/36/250 1,8/26/180 2,5/36/250
165/65R13 2,1/30/210 2,5/36/250 1,8/26/180 2,5/36/250
165/60R14 2,3/33/230 2,5/36/250 1,8/26/180 2,5/36/250
0 1
0 1