Electrical Connection - EBARA Ego 2 Manual De Instrucciones

• Glands must be tightly screwed.
• The pump should not be used as a handle for welding the pipe
• If the gasket between the electro-motor part of the pump and the
• There are openings for condensate drain on the housing of the
• Hot media poses a threat of burns. The pump motor can reach a

4.2 ELECTRICAL CONNECTION

The electrical connection of the pump to the network must be done with the
appropriate power cord (3G1mm2, H05RR-F) to the enclosed connector. The
manual for the connector is in the plastic bag within the pump packaging.
The pump has a built-in overcurrent fuse and protection, temperature protection
and basic overvoltage protection. It doesn't need an additional thermal
protection switch. Connection leads should be capable of carrying rated power
and should be properly fused. Ground lead connection is essential for safety
and should be connected first! Grounding is only meant for pump safety. Pipe
systems should be grounded separately!
• Electrical connection of the pump should be conducted by trained
• The cable connection must be done in a manner that ensures that
• Devices for separating all phases from the power supply must be
• This appliance can be used by children aged from 8 years and
• Children shall not play with the appliance
18
system since it can be damaged.
console is not correctly installed, the pump will not be watertight
and there is a danger of damage to the pump.
electric motor, these must remain free (must not be thermally
insulated), as this may interfere with the cooling of the engine or
the discharge of condensed water (figure 2).
dangerous temperature which poses danger to health!
and qualified personnel!
the cable is never in contact with the casing of the device, due to
the high temperature of the casing.
installed in the electric installation in accordance with the national
installation regulations.
above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved.