Stihl HSE 60 Manual De Instrucciones página 10

English
Check the cutting blades at regular short
intervals during operation, or
immediately if there is a noticeable
change in cutting behavior:
Disconnect the hedge trimmer from
–
the power supply.
Wait until the cutting blades have
–
come to a complete standstill.
Check condition and tightness; look
–
for cracks.
Check sharpness.
–
Replace damaged or dull cutting
–
tools immediately, even if they have
only superficial cracks.
Do not expose to or use
in rain.
After Finishing Work
Always clean dust and dirt off the
machine – do not use any grease
solvents for this purpose.
Spray the blades with STIHL resin
solvent. Start and run the motor briefly
so that the solvent is evenly distributed.
MAINTENANCE, REPAIR AND
STORING
This electric hedge trimmer is double-
insulated. In such an appliance, two
systems of insulation are provided
instead of grounding. No grounding
means are provided, nor should means
for grounding be added to the appliance.
Servicing a double-insulated appliance
8
requires extreme care and knowledge of
the system, and should be done only by
qualified service personnel.
WARNING
Use only identical STIHL replacement
parts for maintenance and repair. Use of
non-STIHL parts may cause serious or
fatal injury.
Do not attempt any maintenance or
repair work not described in your
instruction manual. Have such work
performed by your STIHL servicing
dealer only. Only authorized personnel
may replace the power supply cord.
Never open the powerhead.
WARNING
Always disconnect the plug from the
power supply and make sure that the
cutting tool is stopped before doing any
maintenance or repair work or cleaning
the electric hedge trimmer.
Wear gloves when handling or
performing maintenance on blades.
Strictly follow the maintenance and
repair instructions in the appropriate
section of your instruction manual.
Check cooling air inlets about every ten
hours of operation and clean if
necessary. Do not use any strong
detergents on the plastic housing or
handle. They can be damaged by
certain household cleaners containing
aromatic oils such as pine or lemon, or
by solvents such as kerosene.
WARNING
Never repair damaged cutting attach-
ments by welding, straightening or
modifying the shape. This may cause
parts of the cutting tool to come off and
cause serious or fatal injury.
Keep the cutting tool sharp. Tighten all
nuts, bolts and screws after each use.
Do not spray water on the trimmer;
moisture can cause an electric shock
hazard. Wipe the unit with a dry cloth.
Store the power tool in a dry and high or
locked location out of reach of children.
HSE 60, HSE 70