12
www.electrolux.com
Every time
activated, XtraDry is off and
needs to be chosen
manually.
Activating XtraDry deactivates
TimeManager and vice versa.
How to activate XtraDry
Press Option until the indicator
comes on.
If the option is not applicable to the
program, the related indicator does not
come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated program
duration.
7.2 TimeManager
This option increases the pressure and
the temperature of the water. The
washing and the drying phases are
shorter.
The total programme duration decreases
by approximately 50%.
The washing results are the same as
with the normal programme duration. The
drying results can decrease.
How to activate TimeManager
Press Option until the indicator
comes on.
8. BEFORE FIRST USE
1. Make sure that the current level of
the water softener agrees with the
hardness of the water supply. If
not, adjust the level of the water
softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the
baskets.
If the option is not applicable to the
is
programme, the related indicator does
not come on or it flashes quickly for a few
seconds and then goes off.
The display shows the updated
programme duration.
7.3 MyFavourite
This option allows to set and save the
most frequently used programme.
It is possible to save only 1 programme.
A new setting cancels the previous one.
How to set the MyFavourite
programme
Press and hold Program until the
indicators that are related to the
MyFavourite programme and options are
on.
The display shows the duration of the
programme.
How to save the MyFavourite
programme
1. Set the chosen programme.
It is also possible to set applicable
options together with the programme.
2. Press and hold simultaneously
After starting a programme, it may take
up to 5 minutes for the appliance to
recharge the resin in the water softener.
It seems that the appliance is not
working. The washing phase starts only
after this procedure is completed. The
procedure is repeated periodically.
Program and Delay until the
indicators of the programme and the
options flash for a few seconds.