Stopping The Engine; Using The Machine - EMAK PTX 2710 Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 71
START-UP PROCEDURE
1) Slowly push the purge bulb 4 times (6, Fig.1).
2) Pull the choke lever (11, Fig.1) in the CLOSE
GB
position (A, Fig.9)
3) Pull the throttle lever (14, Fig. 1) and stop it at
half-throttle by pressing the button (17), then
release the lever (14).
4) Place the pole pruner on the ground in a
stable position. Check that the blade is free.
Holding the pole pruner down (Fig.10), pull
the starter rope until the first kick over of the
engine is heard (no more than 3 pulls). A new
unit may require additional pulls.
5) Push the choke lever (11, Fig.1) in OPEN
position (B, Fig. 9).
6) Pull the starter cord to start the engine. Once
the machine is started, warm up the machine
for about few seconds, without touch the
throttle lever. The machine could need more
seconds to warm up with cold weather or at
high altitudes. Finally, push the throttle lever
(14, Fig.1) for deactivate the half-throttle.
Never press on the drive shaft with your
feet!
CAUTION:
- Never wrap the starter cord around your
hand.
- When pulling the starter rope, do not use
the full extent of the rope as this can cause
the rope to break.
- Do not let starter rope snap back. Hold the
starter handle (10, Fig.1) and let the rope
rewind slowly.
WARNING: Once the engine is warmed up
do not use the choke to start up again.
WARNING: Use the semi-acceleration
device only in the phase of starting the engine
to cold.
BREAKING-IN THE ENGINE
The engine reaches the maximum power after
5÷8 hours of activity.
During this period of breaking-in do not use the
24
engine at wide open throttle without load, to
avoid excessive functioning stress.
WARNING! - During the breaking-in
period do not vary the carburetion to obtain a
presumed power increment; the engine can be
damaged.
NOTE: It is normal for smoke to be emitted
from a new engine during and after first use.

6. STOPPING THE ENGINE

Set the throttle lever to idle position (14, Fig. 1)
and wait a few seconds to let the engine cool off.
Turn off the engine, pushing the ON/OFF switch
(13).

7. USING THE MACHINE

PROHIBITED USE
WARNING - The pole pruner must only be
used for cutting branch. It is forbidden to cut
other types of material. Vibrations and
kickback vary with different materials and the
requirements of the safety regulations would
not be respected. Do not use the pole pruner
as a lever for lifting, moving or splitting
objects. Do not lock it over fixed stands. It is
forbidden to hitch tools or applications to the
P. t . o. t h a t a r e n o t s p e c i f i e d b y t h e
manufacturer.
WARNING - Never cut in high wind, bad
weather, when visibility is poor or in very high
or low temperatures. Always check the tree for
dead branches which could fall during the
felling operation.
WARNING!!! Observe great care when
working near overhead power lines. This
machine is not electrically insulated. If the
machine touches or comes close to high-
voltage power lines it could lead to death or
serious injury. Electricity can jump from one

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ppx 271

Tabla de contenido