Troubleshooting - Sony Atrac3plus ZS-XN30 Manual De Instrucciones

Precautions (continued)
Notes on CDs
• Before playing, clean the CD with a
cleaning cloth. Wipe the CD from the
center out.
• Do not use solvents such as benzine,
thinner, commercially available cleaners
or anti-static spray intended for vinyl LPs.
• Do not expose the CD to direct sunlight or
heat sources such as hot air ducts, nor
leave it in a car parked in direct sunlight
as there can be a considerable rise in
temperature inside the car.
• Do not stick paper or sticker on the CD,
nor scratch the surface of the CD.
• After playing, store the CD in its case.
If there is a scratch, dirt or fingerprints on
the CD, it may cause tracking error.
About CD-Rs/CD-RWs
This CD player can play CD-Rs/CD-RWs
recorded in the ATRAC3plus/ATRAC3,
MP3 or CDDA* format, but playback
capability may vary depending on the quality
of the disc and the condition of the recording
device.
* CDDA is the abbreviation for Compact Disc
Digital Audio. It is a recording standard used for
the Audio CDs.
If you have any questions or problems
concerning your player, please consult your
nearest Sony dealer.
GB
26

Troubleshooting

General
The power is not on.
• Connect the AC power adaptor to the mains
securely.
• Make sure the batteries are inserted correctly.
• Replace all the batteries with new ones if
they are weak.
The power is not on, and "Battery Error"
is displayed.
• Make sure the batteries are inserted correctly.
There is no audio.
• Adjust the volume.
• Unplug the headphones when listening
through speakers.
Noise is heard.
• Someone is using a portable telephone or
other equipment that emits radio waves near
the player. t Move the portable telephone,
etc., away from the player.
CD Player
"No disc" lights in the display even when
a CD is in place.
• Place the CD with the label surface up.
• The CD-R/CD-RW was not finalized.
Finalize the CD-R/CD-RW with the
recording device.
• There is a problem with the quality of the
CD-R/CD-RW, recording device, or
application software.
• The CD-R/CD-RW is blank.
• Replace all the batteries with new ones if
they are weak.
The CD does not play.
• Place the CD with the label surface up.
• Clean the CD.
• Take out the CD and leave the CD
compartment open for about an hour to dry
moisture condensation.