Audio Settings menu
1
Press HOME MENU and select 'Audio
Settings' from the on-screen display.
2
Highlight 'Virtual Surround', then use
the Joystick (left/right) to change to '2V/
SRS TruSurround' or 'Off', as required.
Audio Settings
Audio DRC
Legato PRO
Hi-Bit
Virtual Surround
Channel Level
3
Press ENTER to make the setting and
exit the Audio Settings screen.
• You can also use the SURROUND button
on the remote control to switch Virtual
Surround on (2V/SRS TruSurround)/
Off.
• Virtual Surround does not work with CD,
MP3, DVD-Audio or SACD discs, or 96kHz
Linear PCM soundtracks.
• The Virtual Surround effect is output only
through the analog AUDIO OUT (2ch)
jacks.
• Make sure that Audio Output Mode is
set to 2 Channel (see Audio Output Mode
on page 73).
• How good the surround effect is varies
with the disc.
Channel Level
• Default setting: Fix
This setting allows you to set the level of each
channel sent to the 5.1 channel analog
outputs.
1
Settings' from the on-screen display.
2
Joystick (left/right) to change to 'Fix' or
'Variable', as required.
1/ 2
Off
Off
On
Off
Fix
3
(down) to proceed to the next screen.
4
levels for each speaker.
Channel levels can be set from –6 dB to +6
dB. in 0.5 dB increments.
Press HOME MENU and select 'Audio
Highlight 'Channel Level', then use the
Audio Settings
Audio DRC
Legato PRO
Hi-Bit
Virtual Surround
Channel Level
• Fix – Channel levels are fixed, but you can
set the speaker distances
• Variable – You can specify variable
channel levels as well as speaker
distances
If you chose 'Variable', use the Joystick
Audio Settings
Audio DRC
Legato PRO
Hi-Bit
Virtual Surround
Channel Level
Variable setting only: Set the channel
Audio Settings
Channel Level L
Channel Level C
Channel Level R
Channel Level RS
Channel Level LS
Channel Level SW
• Use the Joystick (up/down) to select a
speaker.
• Use the Joystick (left/right) to adjust the
channel level for that speaker.
1/ 2
Off
Off
On
Off
Fix
1/ 3
Off
Off
On
Off
Variable
2/ 3
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
0.0 dB
06
55
En