Pioneer DV-868AVi Manual De Instrucciones página 58

07 Video Settings menu
3 Adjust the picture quality settings.
Memory1
Recall Settings
Prog. Motion
PureCinema
YNR
CNR
Sharpness High
Sharpness Mid
• Use the Joystick (up/down) to select a
setting.
• Use the Joystick (left/right) to adjust the
current setting.
• Press DISPLAY to switch between full and
single view.
• You can recall the preset number from the
Recall Settings menu item.
You can adjust any or all of the following
picture quality settings:
• Prog. Motion – Adjusts the motion and
still picture quality when the player is set
to progressive video output. This has no
effect when set to On.
• PureCinema – When watching DVD
movies, PureCinema optimizes the
picture quality. The default setting is
Auto1, but if the picture appears
unnatural, then set to Auto2, On or Off,
as appropriate.
• YNR – Adjusts the amount of noise
reduction in the Y (brightness) part of the
video signal.
• CNR – Adjusts the amount of noise
reduction in the C (color) part of the video
signal.
• Sharpness High – Adjusts the sharpness
of the high-frequency (detailed) elements
in the picture.
• Sharpness Mid – Adjusts the sharpness
of the mid-frequency (less detailed)
elements in the picture.
58
En
1/3
Memory1
fast slow
Auto 1
soft fine
min max
min max
min max
• Detail – Adjusts the sharpness of edges
in the picture.
• White Level – Adjusts the intensity of
white.
• Black Level – Adjusts the intensity of
black.
• Black Setup – Setup to correct the
floating black color for better 3-
dimensional realism.
• Gamma – Adjusts the brightness of
darker images.
• Hue – Adjusts the overall color balance
between red and green.
• Chroma Level – Adjusts how saturated
colors appear.
• Chroma Delay – Adjust to correct the gap
between the Y and C components in the
video signal. (This setting only affects
progressive video output.)
When the HDMI output is connected, the
following options also appear:
• HDMI Color Adjust – Adjusts the overall
color intensity in the HDMI video signal
(select between Standard and
Enhanced).
• HDMI Detail – Adjusts the sharpness of
edges in the HDMI video signal.
4 Press ENTER to save the preset and
exit the Video Adjust screen.
• Video on a DVD discs may be either video
material (originally shot on video) or film
material (originally shot on film). Video
material has a frame rate of 30 frames/
sec.(NTSC), compared with 24 frames/
sec. for film. This player converts film
material to 60 frames/sec. (in progressive
scan mode). PureCinema adjusts the
picture so that it matches more closely
the picture quality of a cinema screen.