Switching The Appliance On And Off; Filling And Emptying The Well - Angelo Po 0N1CP1EL Manual De Uso

Lighting
Operate the appliance's master switch to
1)
connect it to the electrical mains.
Fill the well ( see pag. 9).
2)
Important
Before fi lling the tank, make sure the drain
lever is on "CLOSED".
Turn the knob (A) to setting 1 to turn on the
3)
heating elements at the maximum power and
bring liquids to the boil more quickly.
The mains light (D) comes on.
Turn the knob (A) to one of the other settings,
4)
to reduce the heating element power to a
lower level.
Turning off
Turn off the water supply (see page 9).
1)
Turn the knob (A) to setting 3 to turn off the
2)
heating elements.
The mains light (D) will go out.
Turn off the appliance's circuit breaker to
3)
disconnect it from the electrical mains.
Filling
To carry out this operation, proceed as follows.
Important
Before fi lling the tank, make sure the drain
lever (L) is on "CLOSED".
Turn on the water tap (B) for to fi ll the well
1)
until the minimum level.
Emptying
Turn the water drain lever (L) to "OPEN" to
1)
drain out the water contained in the tank.
Important
Drain the well completely after use.
3320040_ut_GB_rev.1

SWITCHING THE APPLIANCE ON AND OFF

FILLING AND EMPTYING THE WELL

1
1
A
1 3
2
Important
Drain the well completely after use.
B
CLOSED
OPEN
- 9 -
A
D
3
2
1
2
1 3
2
3
L
3
2
GB
ENGLISH