Fault; Troubleshooting - Angelo Po 0N1CP1EL Manual De Uso

– Take special care not to damage stainless steel
surfaces. In particular, avoid the use of corrosi-
ve products and do not use abrasive materials
or sharp tools.
– Remove food residues immediately before
they set.
The appliance has been tested before being put
into service.
The information provided below is intended to
assist in the identifi cation and correction of any
anomalies and malfunctions which might occur
during use.
The user can solve some of these problems
himself, but for others specifi c technical knowl-
edge or skill is required, and so they must only
be carried out by qualifi ed staff with recognised
experience acquired in the specifi c sector of
operation.
Faults
GB
The heating elements do not
come on
3320040_ut_GB_rev.1
– Remove the limescale deposits which may
form on some of the appliance's surfaces.

FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Electrical connection not
made correctly
Safety thermostat tripped
Switch faulty
- 12 -
Important
Remedies
Check the connection of the
electrical wires
Carry out the appliance reset.
Replace the switch.
Contact the after-sales service.
ENGLISH