Fisher-Price Power Wheels 74598 Manual Del Usuario página 28

N
IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you still experience a problem,
please contact Power Wheels ®
Problem
Vehicle does not run
Vehicle was running but
suddenly stopped
e Problems and Solutions Guide
Consumer Relations.
Possible Cause
Undercharged battery
Charger is not working
Wrong type or improperly installed fuse
Blown fuse
Loose wire or loose connectors
Dead battery
Electrical switch damage
Motor damage
Loose wire or loose connectors
Wrong type or improperly installed fuse
Blown fuse
Vehicle is overloaded
Driving conditions are too stressful
Solution
Charge the battery. A new battery should have been
charged for at least 18 hours before using the vehicle for
the first time. After first-time use, recharge the battery for at
least 14 hours after each use. Never charge the battery
longer than 30 hours.
Check all connectors. Make sure the battery connector is
tightly plugged into the charger connector, and that the
charger is plugged into the wall.
Make sure power flow to the wall outlet is "ON".
There is no sure way to tell if your charger is working unless you
have a volt meter. If you suspect there is a problem with your
charger, contact your local Power Wheels
centre. They can test your charger for you.
Make sure that the battery has a properly installed
Power Wheels ® 25 amp fuse before charging. Do not
substitute parts.
Make sure that the fuse in the battery is in good
condition. Replace a blown fuse with a Power Wheels
25 amp fuse. Do not substitute parts.
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
If your battery is old or if you have not followed Battery
Care instructions, your battery may be dead. If you are
unsure whether or not the battery is dead, contact
Power Wheels ® Consumer Relations.
The electrical switches can become corroded due to
exposure to water or moisture, or can jam due to loose dirt,
sand or gravel. Contact Power Wheels
Contact Power Wheels
Check all wires and connectors. Make sure the battery
connector is tightly plugged into the motor harness
connector, and that there are no loose wires around
the motors.
Make sure that the battery has a properly installed
Power Wheels ® 25 amp fuse installed before charging.
Do not substitute parts.
Make sure that the fuse in the battery is in good
condition. Replace a blown fuse with a Power Wheels
25 amp fuse. Do not substitute parts.
Make sure you do not overload the vehicle by allowing more
than 1 rider at one time, by exceeding the 23 kg (50 lb)
maximum weight capacity, or by towing objects behind
the vehicle.
Use only on generally level ground. Extreme temperatures can
also affect run time.
28
® authorized service
® Consumer Relations.
® Consumer Relations.
®
®