Place the microwave oven unit on top of the universal
connector brackets and fasten in place using three
screws per side in the outside set of holes. Tighten the
screws securely, but do not over tighten.
Continue with the unit installation in the section below
2.
describing installation of the warming drawer
microwave/steam oven unit into the wall cabinet.
Installation into the Cabinet Cutout
Install the warming drawer and microwave assembly
1.
into the cabinet cutout.
CAUTION
9
It is recommended to have 2 installers to install
the unit assembly. Failure to do so may result in
property damage or personal injury.
Slide the assembly into the cabinet cutout until it is
▯
flush with the front of the cabinet.
Secure through screw holes in cleats (drill pilot
▯
holes in cleats first if necessary). See installation
dimensions diagram. Secure microwave according
to installation instructions provided with those units.
Replace drawer.
2.
Be sure cabinet rails are pushed inside cabinet.
▯
Align the rails on the drawer rails with the rails
▯
attached to the drawer housing.
Firmly push the drawer straight into the drawer
▯
housing until the drawer clicks into place. The
drawer should insert easily. If it binds, do not
attempt to force it. Remove the drawer, align the
slides on the housing to the front edge of the
housing and try again. Slide the drawer into both
housing slides at the same time, and keep the
drawer level while doing so.
The drawer has a "push-to-open" operation.
▯
Pressing the front of the drawer inward causes the
drawer to self open.
Open and close drawer to test operation.
▯
Note: If the drawer will not close, verify that the rails
release levers are properly positioned.
Turn power on at the service panel.
3.
Test the installation.
4.
Turn the warming drawer on. Signal light and timer
▯
should turn on immediately.
Check for warmth.
▯
11