Removing Drawer From Housing; Preparing The Storage Drawer For Installation - Thermador Masterpiece and Professional Series Guía Para La Instalación

Removing Drawer from Housing

CAUTION
9
Hidden surfaces may have sharp edges. Use
caution when reaching into, around or under
appliance
NOTICE: The following is the manufacturer's
recommendations for removing and installing the drawer
to minimize the risk of damage to the PTO mechanism.
Remove the drawer from the drawer housing.
1.
Activate the PTO feature by pushing on the front of
▯
the drawer face. Drawer will open approximately 4
inches.
Pull drawer to fully open position.
▯
Press down right drawer release lever.
▯
Lift up left drawer release lever.
▯
Firmly pull the drawer straight out.
▯
Retract cabinet rails while drawer is removed.
▯
Grasp both sides of the drawer and pulling straight
2.
and level, carefully remove the drawer housing. This
step may require light to moderate force to completely
remove drawer.
Install or service (clean) housing with drawer removed.
3.
Preparing the Storage Drawer for
Installation
Remove the storage drawer from the packaging and
place on a sturdy surface such as a table or workbench.
Take precautions to protect the work surface while
preparing the storage drawer for installation. The
cardboard packaging or some other suitable protector
could be used for this purpose.
Once appliance is properly placed on a prepared work
surface, remove the drawer from the unit. Lay the drawer
to the side taking care to protect the stainless steel
surfaces from damage.
13