Attaching The Custom Panel - Thermador Masterpiece and Professional Series Guía Para La Instalación

Attaching the Custom Panel

The custom front warming drawer comes with an
attachment plate pre-assembled to the unit.
Note: Template dimensions are for reference only. The
panel size is at the customer's discretion.
Location Qty. Description
4 Counter bore holes 10mm (7/16") to clear mounting screws (not provided). Depth of bore hole is
A
also 10mm (7/16"). Be careful not to drill through the panel.
8 Pre-drilled to fit mounting screws 2.3mm (1/8") provided (self-tap screw 8 x 1/2 T20 Truss). Depth
B
of bore hole is 10mm (7/16"). Be careful not to drill through the panel.
Notes
The maximum panel weight is 8 pounds (3.6kg).
▯
Panel thickness is 19.05mm (3/4") based on U.S.
▯
standard cabinet thickness.
It is recommended that metal fasteners be used.
▯
Dimensions are in millimeters (mm).
▯
Pre-drill pilot and clearance holes in the custom front
panel as explained in the Installation Procedure chapter
and then proceed as follows.
18
Open the drawer fully by grasping the outer edges of the
attachment plate. Be sure to wear gloves to protect from
cuts from the edges of the attachment plate.