Installation Procedure Wd30Wc, Sd30Wc - Thermador Masterpiece and Professional Series Guía Para La Instalación

Wall Mounted Installation
Thermador® warming drawers may be installed below
any Thermador® single or double built-in oven. A
minimum space of 1" (25.4mm) is recommended
between the bottom of the oven and the top of the
warming drawer.

Installation Procedure WD30WC, SD30WC

The electrical outlet can be installed in the back wall
directly behind the warming drawer. A recessed power
receptacle must not exceed 5
distance from either side of the warming drawer cutout.
Installation clearances permit for the excess power cord
to be coiled behind the appliance.
DO NOT install this warming drawer in wet locations or
outdoors.
WARNING
9
Do not repair, replace or remove any part of the
appliance unless specifically recommended in the
manuals. Improper installation, service or
maintenance can cause injury or property damage.
Refer to this manual for guidance. All other servicing
should be done by an authorized servicer.
NOTICE: This unit utilizes a special ball bearing slide
and locking feature called "Push to Open" (PTO). This
feature allows for a design without a handle and a flush
installation option.
/ ft. (1.7m) maximum
1
2
Under Counter Installation
Thermador® warming drawers may also be installed
below any Thermador® electric or non-Professional
Series gas cooktop as long as there is not contact
between the bottom of the cooktop and the top of the
warming drawer. When installing below a Thermador®
induction cooktop, a minimum 1" (25.4mm) air gap must
be maintained between the bottom of the cooktop and
the top of the warming drawer.
When installing below a Thermador Professional®
rangetop, a minimum 2
maintained between the bottom of the rangetop and the
top of the warming drawer.
There are two PTO slide assemblies installed in this unit,
one on each side. A slide is mounted to each side of the
housing and corresponding rails are mounted to each
side of the drawer. (Only one side is shown in picture for
clarity).
During installation or service (cleaning) it may be desired
or recommended to remove the drawer from the unit to
simplify or aid in installation or service. Special care and
specific steps are recommended to ensure no damage is
done to the PTO mechanism.
CAUTION
9
Before installing, turn power OFF at the service
panel. Lock service panel to prevent power from
being turned ON accidentally.
/ " (70mm) air gap must be
3
4
7