Brother P-touch 9500PC Manual De Instrucciones página 253

■ Connecting to a serial port
A personal computer running Windows
NT 4.0 must be connected to the serial port.
To connect to personal computers running
®
Windows 98/98 SE/Me/2000 Pro/XP using
the serial port, select "Connecting to a serial
port" (→ P.36).
Note
●
When the USB interface cable is
connected to the PT-9500PC, the serial
port cannot be used for communication.
Remove the USB interface cable from the
PT-9500PC.
●
When connecting the PT-9500PC to a
personal computer using a serial
connection, connect the PT-9500PC to
the personal computer with the serial
interface cable before installing the
software.
●
The serial ports (RS-232C) of some
computers are shaped so that the serial
interface cable cannot be connected. In
this case, use a commercially available
adapter.
●
Macintosh computers cannot be
connected to the serial port of the
PT-9500PC.
1 Prepare the included serial interface
cable.
Connect to PT-9500PC
serial port.
18
®
95/
Connect to personal
computer serial port.
Make sure that both the PT-9500PC and
2
the personal computer are turned off.
If the power is on, turn them off.
Insert the plug on the end of the serial
3
interface cable into the serial port on the
back of the PT-9500PC.
Insert the plug on the end of the serial
4
interface cable into the serial port on the
personal computer.
• The location and shape of the serial
port varies according to the personal
computer. For details, refer to the
instruction manual for the personal
computer.