Cleaning The Cutter - Brother P-touch 9500PC Manual De Instrucciones

■ Cleaning tape
Use the TZ-CL6 cleaning tape with a tape
width of 36 mm (sold separately) to clean the
PT-9500PC easily.
Press the cover release button and open
1
the tape compartment cover.
Remove the tape cassette and install the
2
cleaning tape.
Close the tape compartment cover.
3
Press the feed/cut button.
4
→Cleaning will start.
Press the cover release button and open
5
the tape compartment cover.
When the rollers stop, press the cover
release button.
Remove the cleaning tape, reinstall the
6
tape cassette, and then close the tape
compartment cover.
Note
●
For further details on using the cleaning
tape, refer to the instruction manual
included with the cleaning tape.
104

Cleaning the cutter

If the printed labels are not ejected from the
PT-9500PC correctly, clean the cutter for
cutting the labels.
Turn off the PT-9500PC.
1
2 Press the cover release button and open
the tape compartment cover.
Remove the tape cassette.
3
4 Use a cotton swab to clean the cutter.
Cutter blade
Cotton swab
Metal section